Colloquia

Samenvatting

In precision engineering, flexure-based tip-tilt-piston mechanisms usually depend on exact-constraint designs to ensure predictable kinematic behavior. To enhance performance beyond these exact-constraint setups, overconstraining might be considered. While overconstraining can potentially increase stiffness ratios between degrees of freedom (DOF) and support directions, its practical use is often limited by sensitivity to manufacturing, assembly, and thermal misalignments. This research shows that adding commercially available viscoelastic tape to these mechanisms can improve their tolerance to misalignment while maintaining support stiffness. An experimental setup was developed to compare an overconstrained (OC) baseline with configurations using 1, 4, and 8 layers of viscoelastic tape (LVT). By analyzing eigenfrequencies as indicators of stiffness, the study evaluated misalignment tolerance using the DOF rigid-body mode (ω₁ᵉ) and support stiffness via the parasitic mode (ω₄ᵉ).

The results support the proposed approach. Incorporating viscoelastic tape effectively delayed the bifurcation point in ω₁ᵉ, reducing internal compressive stress and increasing misalignment tolerance compared to the OC baseline by factors of 1.51, 2.54, and 2.89 for the 1-LVT, 4-LVT, and 8-LVT configurations, respectively. Importantly, the support stiffness remained consistent, with factors of 1.01 (1-LVT), 0.99 (4-LVT), and 0.97 (8-LVT) for ω₄ᵉ relative to the OC baseline. Additionally, time-based tests showed that the viscoelastic tape enables the mechanism to effectively self-heal, with the fastest stress relaxation occurring within the first 24 hours. In conclusion, this study confirms that dynamically overconstraining with viscoelastic tape is a reliable method for enhancing misalignment tolerance in high-performance flexure mechanisms.